The PVC Embossed Board molding device is composed of a molding machine and a mold. The mold is composed of an upper template, a lower template, and a demolding device. The top of the molding press has a feed hole of the same size as the inner diameter of the diversion barrel. The upper and lower templates of the PVC Embossed Board mold are respectively fixed on the fixed and movable templates of the molding press, and the demolding device is fixed on the molded motorized template. When working, the molding press exerts a certain pressure on the mold, and the mold works repeatedly under high-temperature conditions. So what is the Structural Design of the PVC Embossed Board molding Device? Next, let us take a look.

Here is that the content list:

• Upper template structure design

• The structure design of the lower die plate

• The structure design of the molding device

Upper template structure design

The upper template of the PVC Embossed Board is composed of an upper mold base plate, a punch, and a sliding block. The upper mold base plate is equipped with a circular feed port that matches the feed port of the molding machine. The punch and the upper mold base plate are fixedly connected, and the punch is opened. There are slides to facilitate the sliding of the slider, and a slider to control the feed switch. When the size of the formed PVC Embossed Board is large, a single feed port will make the melt flow longer and prone to corner defects.

The structure design of the lower die plate

The upper template and the lower template of the PVC Embossed Board are connected by guide pillars, and the lower template is connected with the demolding device. The concave mold is composed of a cavity fixed plate and a lower punch. The lower punch is evenly distributed with heating oil channels. By replacing the lower punch, the production of ribbed or semi-cellular PVC Embossed Board panels can be achieved. The positions of the rods should be evenly distributed at the ribs of the plate. The inside of the cavity of the PVC Embossing Board die is uniformly installed with bolts to form honeycomb holes. One end of the bolt has a thread that matches with the screw hole on the bottom of the mold cavity. The bolt is fixed inside the cavity. The forming end of the bolt must have a certain inclination and rounding.

The structure design of the molding device

The PVC Embossed Board molding device is used to push out the formed sheet, which is convenient for the manipulator to remove the sheet for post-processing. The ejector pin is used for the ejection device of the ribbed plate, but the ejector pin is not suitable for the ejection of the semi-honeycomb plate. Therefore, the ejection device of the half honeycomb mold is set as a push plate, and the contact area between the push plate and the plate is large. Will not damage the honeycomb structure. The top plate of the PVC Embossed Board top-plate molding device is fixedly connected with the ejector rod and the ejector pin doubles as a guidepost. The PVC Embossing Board demolding device is fixedly connected with the plunger of the molding cylinder to realize automatic stripping of the plate.

HANGZHOU JIAYING TRADE CO.LTD, specializing in the production of PVC board with its excellent quality, has continuously sold for more than ten years worldwide, such as United States, Europe, Vietnam, Thailand, Malaysia, Indonesia, the Philippines, India, Iran, Saudi Arabic, Taiwan, Fiji, etc. The above is related to the structural design of the PVC Embossed Board molding device. If you are interested in the PVC Embossed Board, you can consult our website https://www.hzpvcboard.com/.